|
Project "Acrylonia" |
|
|
|
Written by Stuyo
|
|
Wednesday, 18 October 2006 |
Page 6 of 21
Part 5 - Small electronic boxes
I needed small boxes to hold all the additional electronics. It was absurd to think that I can use something from the store � the space between the front panel and the hardware was very little. The solution was to make them myself.
The acrylic for the boxes is mirrored on one side and matt on the other. Non-transparent, 2mm.
All the boxed are made with the following technique:
First I paper tape the acrylic and draw the box�s walls.
Cut with the dremel.
Squaring the edges.
And glue them together.
And the again:
This is the box for the fan controller:
|
