Stuyo

Hi Stuyo, I have registered on this site because of an article I saw on the net by yourself, "DIY Waterchill Asetek LCD Written by Stuyo
Monday, 05 November 2007", Thank you for creating this page. I have purchased a 16x2 LCD Module & have used an old FDD cable (modified to only use 16 pins) but when connected I only get to control the backlight, no other information is displayed, am i doing something wrong? not sure if the pins are connected to there correct position on the pump (I think the triangle on the pump pcb means pin 1 but not sure if pin 2 is below or next to the right).

Hope you can help.

Thanks

Niceonez